強弱電之間是不能共槽，否則會干擾弱電的信息傳輸，影響家中電視、電腦、電話的使用，甚至還可能造成火災。

如何避免強弱電干擾?

1.強弱電分開：強弱電要分開走線，禁止共管共盒，且強弱電之間線路的平行距不得小於30cm。

2.不同弱電線也要分開：不同的弱電線在一起也會造成信號干擾，在線路作業時，不同弱電線一定要分開穿管，不可共用同一條管。

3.布線在前走線在後：這樣做能防止出現無法抽動的現象，方便以後進行維護換線。

4.同一管內線路不宜過多：在強弱電線路布設時，所需管數應當根據導線數量而變化，千萬不能有導線把管內空間塞滿的情況。

5.忌避免折斷式直角彎：在施工走線中，不能出現折斷式的轉直角，否則影響信號強度，造成導線無法穿過。

* * * * * *

創世服務有限公司是一間提供專業數據中心架設公司，擁有一群專業團隊貼心地關注客戶的要求，並提供優質的服務。

想了解更多關於「如何避免強弱電干擾」的內容，請瀏覽創世官網：http://livservices.com.hk

地址: 香港觀塘鴻圖道37-39號鴻泰工業大廈4樓4室

電話：852-31063235

——————

How to avoid strong and weak electrical interference?

1. Strong and weak power separation: Strong and weak power should be separated and routed, and it is forbidden to share the common box, and the parallel distance between the strong and weak electricity lines should not be less than 30cm.

2. Different weak wires should be separated: different weak wires will also cause signal interference. When working in the line, different weak wires must be separated and not shared.

3. The wiring is in the front of the wiring: this can prevent the phenomenon of inability to twitch, and it is convenient to carry out maintenance and change lines in the future.

4. The line inside the same pipe should not be too much: when the strong and weak electric circuit is laid, the number of required pipes should be changed according to the number of wires, and there must be no wires to fill the space inside the pipe.

5. Avoid avoiding broken right angle bend: In the construction line, there should be no broken right angle, otherwise the signal strength will be affected and the wire will not pass.

* * * * * *

LIV is a professional data center to set up a company, with a group of professional team intimate attention to customer requirements, and provide quality services.

For more information about 'How to avoid strong and weak electrical interference?'，please visit : http://livservices.com.hk

Address: Unit 4, 4/F., Hung Tai Industrial Building,37-39 Hung To Road, Kwun Tong, Hong Kong

Tel: +852 3106 3235